Here are seven ways to make copper busbars and copper fabrications.
1. Copper fabrication using forming and or bending is performed after the part has been cut to length, punched or milled. Copper forming and bending requires special forming tools and fixtures.
2. Copper stamping, coil processing and die cutting is performed using high speed production presses capable of forming .062” to .375” copper bar stock or coil.
3. Copper cold cutting, shearing or sawing is performed using cold saws to create prototypes and for high or low volume production runs. Continue reading “How does Monti Inc. form and fabricate copper?”
It’s tough as nails and will last a lot longer!
G10 is a fiberglass sheet laminate, a kind of composite material created by stacking multiple layers of glass cloth, soaked in epoxy resin, and then compressing the resulting material under heat until cured. It is made in flat sheets, channels and angles. G10 is very similar to carbon fiber and other high tech fiber epoxy laminates, because they are all resin-based laminates. G-10 is the toughest glass fiber resin laminate and therefore the most commonly used. It is sometimes known as Garolite or Glastic insulator. Continue reading “Why is G10 Material good for electrical insulation?”